FX-1000p-B How it works

The FX-1000p-B is an amperometric chlorine analyzer, which means that the chlorine residual reading (free) is determined by reading the electronic amperage of the measuring cell. The amperage level is directly proportional to the level of free chlorine available in the sample stream.

The cell itself is constructed such that the sample that runs through it, does so at a continuous and fixed rate. Any additional flow is allowed to overflow to waste from a drain below the overflow weir. The sample stream runs down through the lower block where it enter the sample cell chamber. To accurately provide steady readings, the pH entering the sample cell chamber must be steady and not vary no more then .05 +/- pH. The sample cell chamber utilizes a mixer and 150 PVC balls to ensure even sample mix, clean probes, and consistent readings. Very pure grades of gold and copper are used in the construction of the probes to ensure accuracy. Sample flow leaves the cell from the top, and runs out a secondary drain to waste.

The cell probes are connected to the amplifier section of the electronics, where the low-level amperage is boosted and ranged to a useable signal. Specifically, 0 to 5 volts DC. The 0-5 VDC is then input to an isolation amplifier, which provides electrical isolation and an electrical safety barrier. The 0-5 output of the isolation amplifier is then doubled to 0-10 VDC, which is used in the final 3 output stages of the circuit. These are the LED display, the alarm circuit, and the 4-20 milliamp DC output signal. The amplifier board is powered by a dual bi-polar regulated DC power supply, which provides two sets of +12 and -12 Volts. The LED display provides an instantaneous numerical reading of the chlorine residual in parts per million. The alarm circuit provides two user-adjustable alarm level settings that activate two relay outputs, which can be used to control external devices or alarms annunciators. The industry-standard 4-20 milliamp output signal can be used to drive a chart recorder and/ or a chlorine residual control system. The FX-1000p-B chlorine residual analyzer has been designed with control applications in mind, and as such, is an excellent choice for use in process control of chlorine residuals in freshwater.

Amplifier board calibration is done at the factory, with a default range of 0-5 PPM. The unit can be easily re-ranged in the field. The analyzer can be ranged anywhere from the 0-0.5 PPM (mg/l) to a high of 0-60.0 PPM (mg/l). On-site standardization (chlorine residual calibration) is done when the unit is commissioned, and thereafter when needed or desired, using a accurate chlorine residual titrator (or test kit), and chlorinated and non-chlorinated samples of the process waters being analyzed.